Headlamp Motor Assembly

Now I’ve moved the work inside, I’ve started work on a couple of different bits.

The first parts to get my attention were the headlamp lift motors and the wiper motor. The wiper motor is waiting on a couple of parts, but I’ve got one of the headlamp motor assemblies done now (I decided to do them one at a time so I could use the other as a template in case I forgot how it went together).

The start – Functional but seriously grotty:

Headlight assemby 1

The motor assembly:

headlamp-assembly-2

Motor body parts after cleaning, stripping and painting:

assembly-parts-painted

It probably wasn’t needed, but I decided to replace the motor brushes while I was there:

motor-brush-assembly

I also replaced all the wiring – on inspection, it was starting to corrode, even a little way up the insulation. So it all got replaced with some nice modern thin-wall cable, and the connector was replaced with a superseal connector.

As Rimmers were offering new bracket assemblies for dirt cheap money, I didn’t see much point in cleaning them up, so I just replaced them and used the old spring and turnbuckle.

Finished product:

finished-motor-assembly

4 thoughts on “Headlamp Motor Assembly”

    1. Old to New Restorations

      Hi there, I got mine from Stafford Vehicle Components (https://www.s-v-c.co.uk/product/wiper-motor-14w-brush-and-pad/) but I’ve seen them on eBay as well. Just search for ’14W Wiper Motor Brush’ – it’s basically the same as the brush set fitted to the Lucas 14W wiper motor. It’ll come with three brushes, but you don’t need the centre one and you can just remove it. Other than that it’s a direct fit.

Leave a Reply to Red Cancel reply